Flashlight Instruction

1.Install the rechargeable lithium ion 18650 battery by opening the tail cap,inserting it + (positive) first.Screw the cap back on tightly.

2.To power ON/OFF,click the back end of the torch until you hear and feel a click.The torch will then turn on and off.To us the tail switch for use while on a gun simply squeeze the centre of the tail switch.

3.The torch may generate a lot of heat during use.If the torch is being using for a long period it is advised to turn off the torch,so extra heat can dissipate.

4.Keep the reflector clean at all times.Never touch it with a naked hand as it will mark the reflector and it will effect the performance.

5.Never shine directly into eyes.

6.12 month warranty against manufacturers defects.Normal wear and tear is not covered.

Warning

1.This is an extremely bright flashlight,never point toward your eyes or people around you.Do not point at moving vehicles or aircraft.

2.The light is water resistant but not water proof.Do not submerge the light in water.

3.Before hunting with this flashlight,check your state laws to make sure it is legal to hunt at night with aid of an artificial light source.

4.Never take the light apart other than to replace the batteries or led modules.Doing so will void the warranty.

5.If your pressure or on/off switch is attached to your firearm with velcro or any other mounting material or mount,always completely remove the wired pressure or on/off switch from the firearm before unscrewing the tail cap from the light.

Rechargeable Lithium-ion battery instructions:

The Li-ion battery does not have a memory function and it can be charged at any time when you use it. It cannot be over-charged or over discharged. The flashlight should power off to avoid being over charged. It is better to take the battery out when the charger indicator changes.

Caution:

1. Do not expose to extreme heat while charging might cause it to explode.

2. Disconnect the devise if not used for long periods of time and keep away from water, moisture, and chemicals.

Malfunction Repair:

All of our products are examined carefully during production. If there is a problem, follow the steps below.

1.Check that the connectors are screwed tightly in place for the best possible lighting.

2.Examine the battery and make sure that it is in correctly and has sufficient power.

3.Screw off the end cap and connect the battery polarity and the non-oxidized part of the sheet metal or conductor to check if the flashlight will power on.

* If the light works then it is a switch problem. Proceed to step 4.

* If flashlight will not power on check the solder connector’s in the circuit board to check if there is a cold solder.

4.If the light works during step 3, check the switch by screwing off the end cap with a small  tool and find the screw ring with two holes and check for loose LED wire.

Note: it is advised to clean the O-rings with Vaseline 2-3 times per year.